You can resume the download only by clicking Download button.And Installation menu dialog will be displayed automatically.
Conselheiro Aguiar, 903 - Pina - PE CEP: 51011-031 - Tel: 55 81 3268-4009 3265-5166 Filial Blumenau: R. Santa Catarina, 1032, loja 02 - Lourdes - MG CEP: 30170-084 - Tel: 55 31 3390-4130. Rasterlink 5 Sg Upgrade To RasterlinkAlso, I would upgrade to Rasterlink 6 as it is far less glitchy. Ive been having an off and on issue with the contour cutting vinyl on our Mimaki cutter. The machine will feed the correct amount of material and then start cutting horizontal lines in a condensed area and sometimes overlapping the lines and cutting through the wax paper. This doesnt happen all the time, but enough to make me sweat. Sometimes all I have to do to get it to cut properly is reload the vinyl into the machine and re-release the job. The worst part is the wasted material, because it will start cutting at the end of the artwork after feeding all the paper. Rasterlink 5 Sg Registration Marks AndWhen that doesnt work, Ill print registration marks and contour cut using those marks. Im just getting worried now because im going to be getting material where I wont be able to print registration marks, and I wont be able to waste much material since the artwork are going to be approximately 100 in length. Ill check to see if the correct width of the vinyl roll has been recognized, and yes, the machine did scan the correct width of the roll, and the preview looks correct as well. Rasterlink 5 Sg How To Correct ItHas anyone seen this issue or know how to correct it Software used Rasterlink Pro 5 Finecut 8.7.4 Illustrator CC. I have found throughout the years that using FineCut to cut a print that was printed in Rasterlink doesnt always work the best. I have had much more success setting the file up with a CutContour spot color and opening the file directly in Rasterlink. Then print and cut using Rasterlink only and that should help out. Has the font been converted to outlines If not do so and try that. Everytime I print something with registration marks, Ive had practically perfect cuts, its usually when I just contour cut non printed vinyl is where I run into this issue. I will try setting up my file with a CutContour spot colour and put that in the hot folder and hopefully it wont give me any issues.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |